Installing your Dash Kit from wooddashkit.com is simple and by following these easy to follow instructions you will ensure a professional installation that will save you hundreds of dollars. Please email support@wooddashkit.com if you need any assistance. We respond within 24-48 hours.

• Pre-Installation Steps
• · Check Fit and Alignment
• · Clean surface with alcohol wipes.
• · Step 1
  Carefully check fit of each dash piece to ensure proper alignment. Do not remove red backing at this time.
• · Step 2
  Use Alcohol Pad to wipe surface clean. The surface must be free of all debris and oils(armor all,etc) for the kit to adhere properly.
• · Step 3
  Carefully apply adhesion promoter. (included) Only apply to areas to be covered with kit.
• · Step 4
  For larger pieces carefully position dash piece in plate. Carefully pull back top half and remove red liner work from middle back to top then carefully remove red liner and continue with middle to bottom. (For small pieces you can remove entire red liner)
• · Step 5
  To complete installation firmly press dash into position and hold momentarily.
• · Step 6
  After kit is installed use a clean soft cloth and wipe(polish) to finish.